26 _ Troubleshooting
■
Smart Install
Smart Install allows service personnel to check if the dryer is installed properly.
To enter Smart Install
Turn on the dryer, and press and hold the Adjust Time Up + Temp. buttons for 7 seconds.
A message of “
SC
” appears.
Step 1. Check the touch sensor
Enter Smart Install mode, and open the door. The state of the touch sensor appears.
- 0 : Touch sensor open
- 1 : Touch sensor short
Put a wet cloth on the touch sensor to display “
1
”. Removing the cloth displays “
0
”.
Step2. Check the motor and heater
Press the
Start
button to enter the diagnosis mode. The diagnosis result appears.
- OK : Both motor and heater work normally
- HC : Motor or heater doesn’t work normally
To exit Smart Install mode, turn off the dryer.
4-4. ERROR CHECK
