DCS-VIP User Guide
67
parameters.
!
Channel : Select the channel you want MLPPP function for.
!
Circuit Number : If you select X.25 for WAN protocol, enter the virtual circuit
number as X.25. If you select PPP for WAN protocol, enter ‘0’.
!
Administrative Status : If this parameter is set to ‘ENABLE’, the traffic
capacity on the B channel will be monitored and if it is more than the fixed level
the MLPPP function will be used automatically. If this is set to ‘Down’, traffic
capacity will not be monitored, so the MLPPP function cannot be used.
!
Maximum Threshold : Select the
number
and rate of traffic using the MLPPP
function. For example, if you set the traffic rate to 70% and the number to 2
times, the MLPPP function will be used automatically if the traffic rate on the B
channel becomes more than 70% and 2 times.
!
Minimum Threshold : Select the
number
and rate of traffic which deallocates
the MLPPP function. For example, if you set the traffic rate to 20% and the
number to 3 times, the MLPPP function will be deallocated automatically if the
traffic rate on the B channel becomes less than 20% and 3 times.
After finishing setting up all the parameters above, click on the SET button. If you
want to set up an MLPPP function for another channel, click on the NEXT button to
enter the new MLPPP information. Then, click the SET button.
DHCP Relay Setup
On the DHCP Relay Setup screen, you can set up the Relay Agent connecting the
DHCP server to the DCS-VIP system to allocate the IP address automatically using
the DHCP server. Set the following parameter values and click the Set button.
!
DHCP Relay Agent : Select ‘ENABLE’ to use the DHCP Relay Agent.
!
Use DHCP Relay Table : Select ‘ENABLE’ to use the DHCP Relay Table.
Server Table Configurations
!
DHCP Server IP Address : Enter the DHCP server IP address that will receive
packets from the client.
!
DHCP Server Status : Select ‘ENABLE’ to use the DHCP server.
DHCP Server Setup
On the DHCP Server Setup screen, you can set up parameters for the DHCP server.
This includes automatic allocation of IP addresses for the network administrator. Set
the following parameter values and click the Set button.
!
DHCP Server Enable : To use DHCP, select ‘ENABLE’ and set up the following
parameters .
!
DHCP Server Subnet Mask : Enter the subnet mask of the DHCP server.
!
DHCP Server Address Pool Start : Enter the starting IP address that will be
allocated to clients in the DHCP server.
!
Count : Enter the total number of IP addresses that can be allocated to clients in
the DHCP server. The range of parameter values depends on the IP address. For
example, if the address is '10.0.4.20', the range will be 1 ~ 234. If the address is
'xxx.xxx.xxx.0', the range will be 1 ~ 254.
!
Domain Name String :
Enter the domain name to be proceeded by the client
host name.
!
DNS Primary Server : Enter the IP address of the primary DNS(Domain Name
Server). DNS changes URL address such as
www.samsung.co.kr
into an IP address.
!
DNS Secondary Server : Enter the second DNS(Domain Name Server) IP
address. This server will be used if the primary DNS server fails to change a URL
address to an IP address.
