English - 16
English - 17
04
O
V
e
N
U
se
Using mEmory programming.
Press the
number
buttons to select user-programmed memory functions (please refer to
memory programming) from 1 to 20.
Press the
start
button.
If the DEFROST function is included in STAGE COOKING, it works at first.
If you want to change program, just reset MEMORY PROGRAMMING.
Using thE chEck bUtton
Confirming the cooking time and Power Level in each memory program.
1.
Clear all operations by pressing the
stop/cancel
button.
Press the
check
button to enter Check mode.
2.
Using the
number
buttons, enter the program number from
1 to 20.
For example, suppose you press ‘5’, for the Memory
Program 5 which is HI Power Level, I Stage cooking with a
time of 6 minutes and 30 seconds, 6:30.
First, ‘5’ will be displayed. but will change to show the
3.
After one second, the display will clear automatically.
If you want to check other Memory Programs, just enter the
Memory Program numbers.
4.
Press the
stop/cancel
botton to exit the Check mode.
Reading each Memory Program’s Cycle Counter
1.
Clear all operations by pressing the
stop/cancel
button.
Press the
check
button to enter Check mode.
2.
Press the
start
button, and then press any
number
button,
from 1 to 20, and the number of cycles for that particular
Memory Program will be displayed. The cycle count is
displayed in units of 10.
For example, if Memory Program 5 has been used
100 times, the display will show ‘10’.
3.
After one second, the display will clear automatically. If
you want to check other Memory Programs, just enter the
Memory Program numbers.
4.
Press the
stop/cancel
button to exit the Checking mode.
As the display uses units of 10, the cycle counts are approximate. The cycle count
displayed increases every ten cycles.
For example, if the cycle count were 90-99, “9” would be displayed, The “9” would
change to “10” on the 100th cycle. The cycle counter function has a limit of 99,990
cycles. Once that number is exceeded, the cycle counter will automatically clear and
start again from “0”.
rEsEtting thE mEmory program cyclE
coUntEr
1.
Clear all operations by pressing the
stop/cancel
button.
The display will show ‘:0”.
2.
Hold the Number ‘0’ and then press
defrost
button.
The microwave will emit a Beep sound confirming the reset
operation.
Clearing all numbers on the display using the Stop/Cancel
button will show “0” as below.
3.
Press the
stop/cancel
button to exit the Resetting mode.
sEtting thE soUnd
1.
Press the
sound
button to adjust sound volume. The basic
sound volume is “LO” and when you press the
sound
button repeatedly, the sound volume changes in the
following order - MED, HI, OFF, LO one by one.
2.
Press the
start
button to exit
sound
mode. The display will
show “:0”.
indicator
sound
HI
Loud
MED
Middle
LO
Low
Blank
Off
CM1089A_XEU_DE68-03310E-03_EN_160629.indd 17
2016-06-29 �� 2:56:16
