ENGLISH-53
03
O
THERS
1 . Prepare a compressor and the following tools .
Tools
Crimping pliers
Connection sleeve (mm)
Insulation tape
Contraction tube (mm)
Spec
MH-14
20xØ6 .5(HxOD)
Width 19mm
70xØ8 .0(LxOD)
Shape
2 . As shown in the figure, peel off the shields from the rubber or wire of the
power cable .
- Peel off 20 mm of the wire shields of the tube installed already .
• After peeling off the tube wire, you must insert a contraction tube .
• For information about the power cable specifications for indoor and
outdoor units, refer to the installation manual .
CAUTION
(Unit: mm)
120
60
20
20
20
180
Power cable (provided by us)
20
Wire tube power cable
3 . Insert both sides of core wire of the power cable into the connection sleeve .
f
f
Method 1
Push the core wire into the sleeve from both sides .
Connection sleeve
f
f
Method 2
Twist the wire cores together and push it into the sleeve .
Connection sleeve
4 . Using a compressor, compress the two points and flip it over and compress another two points in the same location .
- The compression dimension should be 8 .0 .
- After compressing it, pull both sides of the wire to make sure it is firmly pressed .
Co m p re s s i o n
dimension
f
f
Method 1
Compress it 4 times .
5 mm
f
f
Method 2
Compress it 4 times .
5 mm
How to connect your extended power cables