Connecting the controller
Connect the controller as shown in Fig. 30.
Note!
It is important to observe the system code number and the configuration.
1. Open the casing.
2. Make holes to feed through cables at the marked locations on the top, bottom or back of
the rear casing. Insert the enclosed grommets.
Connecting sensors
Connect cables with a minimum cross-section of 2 x 0.5 mm
2
to the terminal strip of the cas-
ing rear panel.
Connecting actuators and pumps
Guide cables suitable for damp locations with a minimum cross-section of 1.5 mm
2
to the
terminal strip of the controller according to the wiring plan.
EB 5477 EN
87
Electrical connection
!