Samson TROVIS 3730-1, Монтаж и эксплуатация

Страница: 56 / 80

56 EB 8384-1 EN
Code list
Code
Display, values
[default setting] Description
Note: Codes marked by an asterisk (*) indicate that the positioner needs to be re-initialized afterwards
P13 Limit A2
0 to 100 % [98 %]
Software limit value A2 is displayed or can be changed in relation
to the operating range (steps of 0.5 %).
P14 Info w Initialized Indicates the internally adjusted set point in the positioner (adjust-
ed set point in 0 to 100 % according to the settings in P6 and P7 ).
Press to display external set point (applied set point in 0 to
100 % according to the 4-20 mA signal).
Not initialized Displays external set point in 0 to 100 % according to the 4-20 mA
signal.
P15 Start initialization
Press to cancel the initialization process. As a result, the valve
moves to the fail-safe position.
After a power supply failure during initialization, the positioner
starts with the values of the last initialization (if available).
P16 Start zero calibration
The zero calibration process can be interrupted by pressing .
The control valve returns to closed-loop operation.
Note: A zero calibration cannot be started when E1 error code ex-
ists.
After a power supply failure during zero calibration, the positioner
starts with the settings from the last zero calibration.
P17 Manual mode
Turn to enter the set point.
P18 Reset Parameters are reset to their default setting.
The positioner can only return to closed-loop operation after it has
been re-initialized.
P19 Unassigned
P20 Firmware version
Installed firmware version is displayed. Press to display the last
four digits of the serial number.
P21 Control mode
[PD]/PID
Allows an integral-action component to be included in the control
parameters