Samson Media 6 Z, Инструкция по монтажу и эксплуатации

Страница: 33 / 48

EB 9527-3 EN 33
Troubleshooting
10 Troubleshooting
Errors on the LCD are indicated by ERROR at
the top of the display and the associated er-
ror code (e.g.
16 ) shown at the bottom of the
display.
Refer to Table 8 for a list of error codes.
Errors can be reset or confirmed by pressing
the

key.
The reaction to the

key differs depending
on the error class:
Class E1: restarts the device
Class E2: error is suppressed for 8 s
Class E3: error is reset
Class E4: error is reset
All device errors (class E1 to E3) are logged
in an error history, which can be read in
TROVIS-VIEW (V3.11 and higher).
The errors are not saved. Only the error cur-
rently occurring causes the device to switch
to the error mode.
The signal is switched to ≤3.6 mA when
class E1 and E2 errors occur.
Table 8: Error codes
Error code Description Class
1 Oscillating circuit of differential inductor failed E1
2 Checksum error in RAM E1
4 Checksum error in FRAM E1
8 Span outside permissible range E2
16 Error in tank characteristic E2
32 Δp sensor calibration E2
128 Invalid memory pen E4
256 Checksum error in memory pen E4
512 Communication error in memory pen E4
4096 Internal communication error E1
8192 No factory calibration available E1
16384 No LCD available E3
32768 Crystal oscillator failed E3
Error codes can also be added up and displayed as a sum of codes, e.g. ERROR 8 and ER -
ROR 16 ‑> ERROR 24
Note