IP 9519-1 EN
5
Installation
5.
Slide the mating plate underneath the
pointer and magnetoresistive measuring
system to fasten the elements together.
Make sure it fi ts properly. Pay attention
to the counterweight at the end of the
pointer.
Pointer in zero position
with attached
magnetoresistive
measuring system
Mating plate pushed on
Magnetoresistive measur-
ing system with mating
plate
Magnetoresistive
measuring
system
End of pointer
with counter-
weight
Mating plate
Pointer axis
Pointer
Fig. 5:
Fixing the magnetoresistive measuring
system
6. If the terminal board has not yet been
connected, connect the connecting cable
and connector at the back of the printed
circuit board.
Plug the micro connector into the socket
on the printed circuit board.
Connector
Fig. 6:
Back of the printed circuit board
Connector for the terminal board
7. Place on the current output option mod-
ule with connected terminal board in
place of the cover plate.
Three fastening
screws (Phillips
Z1)
Fig. 7:
Current output option module
Fastening screws
8. Fasten the option module using the three
fastening screws (Phillips Z1)
