Samson EB 01a, Монтаж и эксплуатация

Страница: 27 / 76

4-1
EB 01a_EN
March 2023 edition
Subject to technical changes
Shipment and on-site transport
4 Shipment and on-site transport
The work described in this chapter may only be performed by
specialist personnel quali
fi ed to perform the corresponding task.
Damage to the valve due to improper transport and storage!
Ö
Valves with lining must be handled, transported and stored
with care.
4.1 Accepting delivery
Perform the following steps after receiving the goods:
Ö
Check the scope of supply. Compare the delivered goods
with the delivery note.
Ö
Check the supply for transport damage. Report transport
damage to PFEIFFER and the transport company (see the
delivery note).
4.2 Unpacking the valve
Damage to the plastic lining!
Protect the lined valve surfaces in particular prior to/during
installation.
Ö
Transport the valve in its original packaging to the installation
site and unpack it only there.
Perform the following steps before lifting and installing the valve:
Ö
Unpack the valve.
Ö
Dispose of the packaging properly.
Damage to the valve due to the ingress of foreign matter!
The protective caps on the valve inlet and outlet prevent foreign
matter from entering the valve and damaging it. Only remove the
protective caps prior to installation in the pipe.
4.3 Transporting and lifting the valve
Danger due to falling of suspended loads!
Do not stand under suspended loads.
NOTE
NOTE
NOTE
DANGER
Overturning of the lifting equipment and damage to the load
lifting equipment by exceeding the lifting capacity!
Ö
Only used approved lifting equipment and load lifting
equipment whose lifting capacity corresponds at least to the
weight of the valve including the actuator.
Ö
Take the weights from the respective data sheet.
Danger of injury due to the tipping of the valve!
Ö
Observe the centre of gravity of the valve.
Ö
Secure the valve against tipping and twisting.
Damage to the valve due to improper fastening of the sling!
The welded-on lifting eyes on SAMSON actuators are used only
for actuator assembling and disassembling as well as for lifting
the actuator without the valve. This lifting eye is not intended for
lifting the complete valve.
Ö
When lifting the valve, make sure that the entire load is
carried by the sling that is fastened to the valve body.
Ö
Do not fasten the load-bearing sling to the actuator, hand
wheel or other components.
Ö
Do not use the control air lines, accessories or other
components with safety functions for suspension or damage
them.
4.3.1 Transporting
The valve can be transported using lifting equipment such as a
crane or a forklift.
Ö
Leave the valve on the pallet or in the transport container for
transport.
Ö
Valves that weigh more than approx. 10 kg should be
transported on a pallet (or supported similarly) (also to the
installation site). The packaging should protect the scratch-
sensitive plastic lining of the valve against damage.
Ö
Comply with the transport conditions.
Transport conditions
Ö
Protect the valve against external in fl uences, such as impacts.
Ö
Do not damage the corrosion protection (paint, surface
coating). Repair damage immediately.
Ö
Protect the valve against moisture and dirt.
4.3.2 Lifting
When installing the valve in the pipe, heavier valves can be
lifting using lifting equipment such as a crane or forklift.
WARNING
NOTE