Modifications in the positioner firmware compared to earlier version
Old
New
Control
R 1.23
R 1.31
Firmware adaption for new hardware version
Hardware version device index
.01
Control R 1.31
R 1.4
Actuator type
When the actuator type is set from "linear actuator" to "rotary
actautor", the following applies:
Initialization method ............Based on maximum range
Transmission code ...............S90
Nominal angle ....................90°
Final position for w <...........1 %
Final position for w >...........99 %
Rotat. angle range begins.....0°
Rotational angle range ends.90°
When the actuator type is set from "linear actuator" to "rotary
actautor", the following applies:
Attachment
.........................
Integral
...............................
According to NAMUR
Type of initialization.............Based on nominal range ......Based on nominal range
Mounting position................Arrow towards actuator .......Arrow away from actuator
Transmission code.................D1 ......................................
Pin position...................................................................A
Rated travel..........................15 mm ................................15 mm
Final position for w < ............1 % .....................................1 %
Final position for w > ............125 % .................................125 %
Lower travel range value........0 mm ..................................0 mm
Upper travel range value .......15 mm ................................15 mm
Lever length...................................................................42 mm
Type of initialization
When the initialization method is set from "maximum range" to
"nominal range", the following applies:
Final position for w < 1 % Final position for w > 125 %
When the initialization method is set from "maximum range" to
"nominal range", the following applies:
Final position for w < 1 % Final position for w > 99 %
Desired transit time
Open/Closed
The adjustment range of the desired transit times was limited to
75 seconds.
Initialization
During initialization, the minimum control signals from 20 % to
80 % of the range of the manipulated variable are determined
and saved in the EEPROM.
Firmware modifications
EB 8382-2 EN
5
Содержание 4785
