Samson 3349, Монтаж и эксплуатация

Страница: 7 / 104

EB 8048-2 EN 1-1
Safety instructions and measures
1 Safety instructions and measures
Intended use
The SAMSON Type 3349 Angle Valve in combination with an actuator (e.g. Type 3271,
Type 3277 or Type 3379 Pneumatic Actuator) is designed to regulate the flow rate, pressure
or temperature of liquids, gases or vapors. The angle valve is suitable for use in aseptic ap-
plications (e.g. in the pharmaceutical and food industries).
The valve with its actuator is designed to operate under exactly defined conditions (e.g. oper-
ating pressure, process medium, temperature). Therefore, operators must ensure that the con-
trol valve is only used in operating conditions that meet the specifications used for sizing the
valve at the ordering stage. In case operators intend to use the control valve in applications
or conditions other than those specified, contact SAMSON.
SAMSON does not assume any liability for damage resulting from the failure to use the de-
vice for its intended purpose or for damage caused by external forces or any other external
factors.
Î
Refer to the technical data and nameplate for limits and fields of application as well as
possible uses.
Reasonably foreseeable misuse
The control valve is not suitable for the following applications:
− Use outside the limits defined during sizing and by the technical data
− Use outside the limits defined by the valve accessories connected to the valve
Furthermore, the following activities do not comply with the intended use:
− Use of non-original spare parts
− Performing service and repair work not described
Qualifications of operating personnel
The control valve must be mounted, started up, serviced and repaired by fully trained and
qualified personnel only; the accepted industry codes and practices must be observed. Ac-
cording to these mounting and operating instructions, trained personnel refers to individuals
who are able to judge the work they are assigned to and recognize possible hazards due to
their specialized training, their knowledge and experience as well as their knowledge of the
applicable standards.
Welding operations must only be performed by personnel who has the necessary qualifica-
tion to perform the applied welding procedure and handle the materials used.