Samplex Europe SEC-1245E, Руководство пользователя

Страница: 19 / 39

PREPARING THE CHARGER FOR OPERATION
AC INPUT CONNECTION
The charger is pre-set to operate from input AC voltage of 230 VAC, 50 Hz and is
provided with a 1.8 M attached cord with European type plug. Please ensure that the
AC outlet is 2 pole, 3 wire grounding type - European type.
CONNECTING THE BATTERIES OR OTHER DC LOADS
The output of the charger has a common Negative (-) connector (3) and 2 Positive
connectors(1, 2) for connection of 2 banks of batteries. Each Positive connector
has its own internalisolating diode which works as a battery isolator. If more
than one bank of batteries is connected, these will be charged at the same time as
long as the AC power is available to the charger (the maximum charging current
of 45A of SEC-1245E , 60 A of SEC-1260E, 80 A of SEC-1280E, 25A of
SEC-2425E and 40 A of SEC-2440E will be shared among the connected
banks of the batteries depending upon their discharged states). In case the
AC power fails or if there is no output from the charger, the isolating diodes
will prevent charging / discharging among the batteries connected to the banks.
CAUTION! When a single bank consisting of more than one battery in parallel is to
be charged, make sure that their negatives are connected to the common
negative connector (3) of the charger and their positives are connected to the same
positive connector ( either 1 or 2) of the charger. For example, when charging a bank
consisting of 3 batteries connected in parallel, their 3 negative terminals should be
connected to the common negative terminal (3) of the charger and all their 3 posi-
tive terminals should be connected to the same positive terminal of the charger
( either 1 or 2). Alternatively, the negative terminals of the 3 batteries should first be
shorted and then connected to the common negative terminal (3) of the charger and
similarly, the 3 positive terminals of the battery should first be shorted and then
connected to one of the2 positive terminals of the charger (either 1 or 2). When
connecting a single battery or other DC load, it can be connected to the common
negative(3) and any one of the 2 positive terminals (either 1 or 2)
Page 18