S1
• Turn the levers
(
S2
)
to release residual pr
essure.
S2
Max oil level
AGIP DICREA 150 type hidraulic oil
AGIP DICREA 150 type hidraulic oil
www.larius.com
22
VIKING LINER PLUS 2K
ED. 03 - 01/2021 - Cod. 150161
Always check that there is oil in the motor.
If the equipment is still under pressure after
performing the operations above described be-
cause of the nozzle or the flexible hose clogged,
proceed as follows:
• Loosen very slowly the gun nozzle.
• Release the safety clamp.
• Point the gun towards the collecting container
of the product and press the trigger to release
pressure.
• Loosen very slowly the connection fitting
from the flexible hose to the gun.
• Clean or replace the flexible hose and the
nozzle.
• Repeat the same procedure for
gun 2.
S
R
MOTOR OIL CHECK
Every 100 hours check the oil level through the dedicated oil
plugs on the base of the engine.
Refil the oil level if necessary.
CORRECT PROCEDURE OF DECOMPRESSION
• Press the switch
(
S1
)
to spray the product and discharge
the residual pressure from the
gun 1
.
ROUTINE MAINTENAINCE
TOP UP HYDRAULIC OIL
With each start up, check the hydraulic oil level by looking through
the gauge on the side of the hydraulic body. If necessary, use
to top up the level:
REPLACING THE HYDRAULIC OIL
After operating for 100 hours, replace the oil in the pump;
• Discharge the waste oil through the
hydraulic filter
fitted at
the bottom of the pump casing.
• Clean and, if necessary, replace the worn seals.
• Replace the filter in its seat by screwing it tightly.
• Fill the pump with the recommended oil until it reaches the
maximum level.
• Then, replace the oil every 250 hours.
Fig. 1S
Fig. 2S
Fig. 1R
