5
6
7
8
9
10
11
5.- Heating status
6.- Actual water temperature
7.- Estimated heating time
8.- SET timer (target)
9.- SET temperature (target)
10.- Timer status
11.- Timer countdown
12.- Temperature during the cycle
13.- Water heating kWh
14.- SET temperature symbol
15.- Actual temperature symbol
16.- Cycle time
17.- kWh during the cycle
18.- Actual needle probe
temperature
19.- Time passed
20.- SET needle probe temperature
12
13
14
15
16
17
18
19
20
Characteristics
Working with the needle probe
(Only with SmartVide 8)
Change
º
C/
º
F
Calibration
Connect the needle probe
to the machine.
SET set temperature
of the needle probe
at which we want it
to warn us.
Press PLAY to save
the data.
.
Peep, Peep...!!!
It has reached the
temperature.
Indicates the time passed.
Press any button to
view stop the beeper sound.
Press END to finish
the cycle.
End!
SUMMARY of the cycle.
Press any button
for a new cycle.
1.- Machine off.
2.- Holding down the
SETbutton, switch on
the machine.
3.- Change the unit.
1.- Machine off
2.- Holding down the – and + buttons, switch
on the machine.
3.- CALIBRATION screen
4.- Adjust the value with SET and the – and +
buttons
5.- Turn off and on again.
Temperature
sensor
water
Stirrer motor
Heating
element
Overheating
cab
Lack of water. Fill.
Power cut during the cycle.
Indicates temperature before and
after the power cut
Note: Call a Technical Service
Fault warning
Warnings
Reset
1.- Machine off.
2.- Push and hold “SET”, “-” and “+”, switch the machine on.
3.- Hold for 10 seconds until the machine makes a distinct sound.
4.- Turn off and on again.
