SAMES KREMLIN PU3000 2L 53/1, Перевод с оригинала инструкции

Страница: 83 / 135

SAMES KREMLIN Page 71 Manual : 573.199.112
Upper packing (9)
Disassembly
Disassemble the coupling rod from the air motor
and the piston (3) from the fluid section.
Unscrew the wetting-cup (4) by means of the
wrench provided with the pump.
Unscrew the cylinder (2) and pull the piston (3)
downwards. Pull the upper packing (9) upwards
and remove the seals (10 and 11).
Reassembly
Change the seals (10 & 11) and lubricate
them.
On the support washer (12), install the seals (10 &
11) (
comply with orientation and order ) as well
as the blocking washer (13) {  upper packing
(9)}.
12
11
10
13
Ind. 9
You must install a seal (11), then another one
(10) according to the opposite drawing
.The first
seal in contact with the material must be the stiffer
one.
Grease the cone shapped tool (the tool is
supplied with the fluid section).
Position the upper packing (9) on the tool (53).
Slide the piston (3) into the flange (1) by inserting
it from bottom to top.
Position the tool equipped with the seals on the
upper part of the piston.
Slide the seals on the piston. The tool prevents
from damaging the seals when assemblying the
piston.
Remove the tool.
Position the seals (always set up on the piston)
into the upper flange (1).
4
1
11
10
3 à 8 mm
12
Hold the piston to prevent from its sliding downwards.
Tighten by hand the wetting-cup (4) without tightening the upper flange (1).