Index revision : F - November 2017
33
7012
7.2.2. Outer cover
•
Step 1
: Remove the shaping air assembly
•
Step 2
: Leave to soak in solvent the outer
cover for one hour, then clean the outer
and inner surfaces using a rag soaked in
solvent.
•
Step 3
: Using a nylon brush, clean all the
holes located on the front face of the outer
cover.
•
Step 4
: Dry carrefully with compressed air
insisting on the holes to eliminate the paint
residues, then wipe with a clean, dry rag.
•
Step 5
: Check the shaping air shroud, clean
it if necessary using a rag soaked in solvent.
7.2.3. Injector and injector holder
• Remove the injector
see § 6.6 page 28
• Leave to soak for one hour in MEK solvent (methylethylketone).
• Dry carefully with compressed air
• Proceed in reverse order to reassemble.
1
Outer cover
2
O-ring
3
Shaping air shroud
DES03402
1
2
3
DES03378
Solvent
