Operator’s manual
Rotary rake
Z-300; Z-300 Slim; Z-301; Z-301 Slim;
Z-350; Z-350 Slim; Z-351; Z-351 Slim;
Z-410; Z-440; Z-470
- 23 -
6.
MOUNTING AND ADJSUTMENTS
6.1.
Mounting and timing of the tines
The tines should be mounted as shown in
Fig. 27
.
Fig. 27.
Mounting of rake’s tines
WARNING:
Use only the tines recommended by the manufacturer.
Check condition of tines before each operation. Worn or damaged tines
should be replaced immediately.
CAUTION:
Mount and dismount rake tines only if the drive is off and engine shut down
and ignition key out.
6.2.
3-point linkage support chain
Support chain is used to ensure 3-point linkage frame of the rake is always at the same height,
to set the raking unit parallel to the ground and to relieve the hydraulic lift of the tractor.
When connecting rake to the tractor the end of the chain should be put on upper linkage.
6.3.
Daily maintenance
Everyday after work please do the following:
check all visible parts and components and their connections; tighten all loose bolts and nuts
and replace all damaged and/or worn parts with new genuine ones,
clean the rake,
remove grass and mud,
check rotor’s condition,
grease PTO shaft tubes with STP grease,
if necessary, lubricate the parts and units according to lubrication instructions (chapter 7).
Parts which may cause risk to operator’s health and safety are as follows: missing or damaged
safety covers, PTO shaft guides, worn or missing tines.
Driving direction
Gear's rotation
direction