Operator's Manual
Round bale wrapper
Spin S, Spin F
- 34 -
11.
WRAPPING MACHINE STORAGE
After yhe working season is over, clean the wrapping machine and check the conditio of the
protective paint coating. Touch up the damage to the paint coating at a service workshop. Check the
conditio and legibility of the nameplate. If the plate is damaged, notify the service station. Check
the conditio and legibility of the symbols. If they are damaged, replace tchem with new ones.
The wrap counter should be stored in a dry place with the electrical connections protected
against fouling and humidity.
The sensor cable should be folded and stored in a dry place with the electrical connections
protected against fouling and humidity.
Store the wrapping machine on a hard, flat, level ground.
It is advised to store the wrapping machine in a dry location, protecting it against UV rays and
other harmful agents.
If the wrapping machin eis stored without any canopy roof, protect it with a water-resistant
tarpaulin or film.
NOTE:
Store the wrapping machine in an atmosphere free of aggresive agents (e.g.
ammonia, chemicals).
12. PROBLEMS AND THEIR REMEDIES
No.
Problem
Possible cause
Remedy
1.
Wrapping machine’s hydraulic
actuators work slowly or do not
work at all.
Not enough oil in the
tractor’s hydraulic system.
Check the oil level in
the tractor. Top up oil.
Pressure in the tractor’s
hydraulic system to low.
Check the tractor
hydraulic system
pressure.
Wrong diameter setting of
the external diameter
lever.
Turn on the pump
drive.
Damaged actuator.
Replace the actuator.
2.
The wrapping machine works to
slowly.
Not enough oil in the
tractor’s hydraulic system.
Check the oil level in
the tractor. Top up oil.
3.
Oil leaks from the control unit.
Worn seal rings.
Replace the seal rings
on the hydraulic control
unit.
4.
Too wideo r too narrow
overlapping or film edges during
wrapping.
Improper installation of
the chain wheel.
Replace with a proper
chain wheel
(par. 8.1.).
5.
The cut film is not held in the
cutter unit.
The rubber clamp holding
the cut film is not adjusted
properly.
Adjust the film pressure
element (par. 8.5.).
6.
Problems with bale unloading.
Rotary table lock does not
operate.
Lock the table (par.
8.2.).
