Operator's manual
Arm
Flail head
- 25 -
Fig. 25. Location of centre of gravity for flail heads
Tab. 6. Location of centre of gravity for flail heads
Dimension
[mm]
Type
KW 110
KW 111
KW 125
KW 126
KW 140
KW 141
A
780
605
870
670
980
780
B
280
300
280
300
280
275
C
480
520
480
520
480
520
Dimension
[mm]
Type
LAMA
101 P
LAMA
120
LAMA
120 P
LAMA
121
LAMA
121 HD
LAMA
140
LAMA
141
A
590
800
850
660
690
890
760
B
360
240
330
340
350
240
340
C
500
400
500
540
490
400
540
4.4.
Working parts
Prior to operating the machine check flail knives condition.
Worn or damaged knives should be replaced immediately with new ones.
4.5.
PTO shaft
Before operating learn provisions found in bar manufacturer's manual placed on the bar.
PTO shafts recommended by the machine's manufacturer shall only be used.
In order to operate safely use only fully technically fit, undamaged PTO shafts. Damaged PTO
shaft shall be repaired or replaced with new one.
4.6.
Hydraulic assembly
Elastic hydraulic hoses should be checked regularly and if any damage occurs or they expire,
replace with new ones. Replaced hoses must conform with the manufacturer's technical
requirements.
Prior to performing service works at hydraulics the tractor's engine should be stopped and ignition
key taken out.
It is not acceptable to adjust sweep valves on factory set distributors.
Do not drain oil onto the ground, to the sewage system, into rivers or lakes. Only tight tanks
should be used for temporal storing of used oils.
Used oils contain substances harmful for the natural environment and should be delivered to
a proper used oil treatment plant.
Thermostat turns ventilator for cooling oils for temperature over 65ºC on, if oil is heated up to
approx. 90º interrupt work and find cause of high temperature.
