Operator's manual
Arm
Flail head
- 3 -
2.
INTRODUCTION
This operator's manual should be considered as the machine basic equipment. If the mower is
handed over to another operator, it should be in working condition, along with operator's manual,
EC declaration of conformity and its basic equipment.
Prior to operating the machine its user must familiarize himself with this manual as well as
common work safety rules.
The machine is manufactured in accordance with requirements of safety standards.
Respecting recommendations herein shall ensure operation safety.
If you have any questions related to commission and operation of the machine, please contact
the manufacturer.
This operator’s manual is an indispensable part of any machine and is intended to familiarize a
machine user with principles of proper operation and use of the machine as well as the risks
involved.
GENERAL PRECAUTION
When operating the machine warnings and safety rules marked with this sign
herein should be respected.
CAUTION:
Operating the machine without previous familiarizing with its content as well
as by unauthorized personnel, and especially by children, is strictly forbidden.
3.
PROPER USE
Arm with flail head is set on tractors with power of min (Tab. 1) Mounting the arm is
performed on rear 3-point linkage, with which are farming tractors equipped as standard. Rear PTO
must be set on 540 rpm (upon special order 1000 rpm).
Machine are designed for treatment of land drainage ditches in particular as well as mowing of
road shoulders, shredding thinner trunks (Tab. 2), small shrubs, weeds, etc. of moderate
concentration as well as mowing road shoulders, slopes, counter-slopes and ground at tractor's right
side. Moreover the mower can be used to trim hedges both in vertical and in horizontal position. The
arm can be additionally equipped with adapters offered by the SaMASZ co. Arms work properly on
grass (and other plants) with height up to 1.0 m. Heads are designed for shredding cut tree branches,
mowing weeds, shrubs and grass.
CAUTION:
Basing on experience, upon driving onto single shrub with section up to
approx. 2 cm, the tractor should be stopped for a while, until the machine
shreds the shrub at the ground, and then slowly with intervals drive forward,
so there occurs no cutterbar locking.
CAUTION:
Use of the machine for purposes other than mentioned herein is forbidden.
Different use than the above mentioned shall be considered as improper and
may lead to revoking of the warranty. The machine should be operated,
maintained and repaired only by personnel familiarized with its detailed
specifications and safety rules and procedures. Willful modifications to the
machine may lead to revoking of the warranty.
