Operator's manual
Trailed disc mowers
KDC
- 29 -
5.7.
Unmounting the machine from tractor
WARNING:
When dismounting, make sure there is no person in between the machine
and the tractor.
To dismount the machine from the tractor:
Set the machine onto an even, stable ground,
deactivate cutterbar drive, ignition of tractor and removing the key of the tractor’s ignition
lock,
reduce the pressure in the tractor's hydraulics,
Secure the machine against moving by placing wedges at wheels,
Fold out the support leg and protect with safety pin,
Disconnect the machine's hydraulics and electrics from the tractor,
Dismount the telescopic articulated shaft and place it on the shaft holder, which is standard-
delivered with the machine,
disengage the machine from hangers of the tractor's lower links by lifting the three-point
linkage,
carefully drive the tractor away.
5.8.
Storing
Mower should be stored on a hard, flat and level surface, under dry, roofed place to protect it
from atmospheric precipitation. It is forbidden to remove a support preventing tilting single-axis
equipment to the front or to the rear, if this is not required for work purposes.
6.
MOUNTING AND ADJUSTMENTS
6.1.
Mounting knives and timing of the knives
The knives should be mounted as shown on
Fig.18, Fig. 20
. Mount the knives so that cutting
edges are directed towards the ground, so that a knife lifts the grass after cutting.
Fig. 18.
Mounting of the knives on mowing discs
WARNING:
- Use only knives recommended by manufacturer.
- Check condition of knives before each operation. Worn or damaged knives
should be replaced immediately.