SAM4S ER-230EJ Manual
Getting Started
• 25
Clearing Memory
Before you use your ER-230EJ ECR for the first time, you
must
perform a memory all
clear to insure that all totals and counters are cleared and that the default program is
installed.
CAUTION: The procedures described in this area are security sensitive. Clearing the
ER-230EJ memory after the register is put into service will erase all programming as
well as totals and counters. Do not share this information with unauthorized users
and distribute the “SERVICE MODE” only to those you may want to perform these
functions.
1.
Move to the
SERVICE
MODE
.
2.
Turn the power switch located on the right side of the register to the
OFF
position.
3.
Press and hold the key position where the
CHEQUE
key is located on the default
keyboard layout.
4.
Continue to hold the appropriate key while turning the power switch to the
ON
position. The message “
RAM ALL CLEAR
" displays.
5.
Press the upper left key of the keyboard, then the lower left key, then the upper
right key, and finally press the lower right key.
CHEQUE
3
4
00
3
1
2
6.
The SERVICE MODE menu displays. The RAM Clear procedure is complete and
the receipt prints.
7.
If you want to allocate memory by default value, Press
CASH
key only.
LOAD DEFAULT SET
N=X/TIME Y=CASH
Or follow the On-screen prompts.
PLU #
1000
