Precaution Statements
Follow these safety, servicing and ESD precautions to prevent damage and to protect against potential hazards
such as electrical shock.
1-1 Safety Precautions
1. Be sure that all built-in protective devices are
replaced. Restore any missing protective
shields.
2. When reinstalling the chassis and its
assemblies, be sure to restore all protective
devices, including non-metallic control knobs
and compartment covers.
3. Make sure there are no cabinet openings
through which people - particularly children -
might insert fingers and contact dangerous
voltages. Such openings include excessively
wide cabinet ventilation slots and improperly
fitted covers and drawers.
4. Design Alteration Warning:
Never alter or add to the mechanical or
electrical design of the SECR. Unauthorized
alterations might create a safety hazard. Also,
any design changes or additions will void the
manufacturer’s warranty.
5. Components, parts and wiring that appear to
have overheated or that are otherwise
damaged should be replaced with parts that
meet the original specifications. Always
determine the cause of damage or over-
heating, and correct any potential hazards.
6. Observe the original lead dress, especially
near the following areas: sharp edges, and
especially the AC and high voltage supplies.
Always inspect for pinched, out-of-place, or
frayed wiring. Do not change the spacing
between components and the printed circuit
board. Check the AC power cord for damage.
Make sure that leads and components do not
touch thermally hot parts.
7. Product Safety Notice:
Some electrical and mechanical parts have
special safety-related characteristics that
might not be obvious from visual inspection.
These safety features and the protection they
give might be lost if the replacement
component differs from the original - even if
the replacement is rated for higher voltage,
wattage, etc.
Components that are critical for safety are
indicated in the circuit diagram by shading,
(
) or (
). Use replacement components
that have the same ratings, especially for
flame resistance and dielectric strength
specifications. A replacement part that does
not have the same safety characteristics as
the original might create shock, fire or other
hazards.
CAUTION
There is the danger of explosion if batteries are
incorrectly replaced.
Replace only with the same or equivalent type
recommended by the manufacturer.
Dispose used batteries according to the
manufacturer’s instructions.
ATTENTION
ll y a danger d’explosion s’il y a remplacement
incorrect de la batterie.
Remplacer uniquement avec une batterie du même
type ou d’un type équivalent recommandé par le
constructeur.
Mettre au rebut les batteries usagées
conformément aux instructions du fabricant.
SAFETY OTICE:
For pluggable equipment, the
For pluggable equipment, the
For pluggable equipment, the
For pluggable equipment, the socket
socket
socket
socket-
-
-
-outlet
outlet
outlet
outlet should
should
should
should be installed near
be installed near
be installed near
be installed near
the equipment and sh
the equipment and sh
the equipment and sh
the equipment and should
ould
ould
ould be easily accessible.
be easily accessible.
be easily accessible.
be easily accessible.
Содержание ER-180Series
