background image

Electrical

Plumbing

3

/

4

" VALVE (NF)

1

1

/

2

VALVE (NF)

1

1

/

2

PIPING (NF)

3

/

4

" PIPING (NF)

45

O

GUSHER HEAD (OPTIONAL)

  1

5

/

16

" HOLE REQUIRED

2" RESERVOIR

DRAIN

3" DISPOSER

DRAIN

DIFFUSER

  2" HOLE 

REQUIRED

Plumb 1

1

/

2

” pipe from the 1

1

/

2

” rubber coupler supplied on the end of the TroughVeyor unit 

to the far end of the fabricated trough and attach it to the water diffuser (Refer to the Diffuser 

Installation Detail in the Fabricator Instructions on page 2). A 1

1

/

2

” valve must be installed 

as close to the end of the fabricated trough as possible to regulate pump flow capacity. If 

optional gusher heads are to be mounted along the fabricated trough for scrapping and pre-

flushing, they should be connected to the main 1

1

/

2

” recirculation line reducing to 3/4” with a 

3/4” valve in each gusher head line to regulate the flow. Allow 3’ between gusher heads to 

accomodate one operator per gusher head. Configure gusher head plumbing as shown to 

reduce splash when starting TroughVeyor.

AIR GAP

WATER BLENDER

HOT WATER

CONNECTION

COLD WATER

CONNECTION

COLD WATER

CONNECTION

HOT WATER

CONNECTION

WATER SUPPLY

The Salvajor TroughVeyor is designed for easy plumbing installation. The 

solenoid valves are factory installed and are attached to an automatic water 

blender which will introduce water tempered to approximately 107˚ F. Plumb 

3/4” lines from both hot and cold water supply sources and reduce to 1/2” 

before attaching to corresponding valves on the TroughVeyor water harness.

IMPORTANT:

 The TroughVeyor is equipped with an approved air gap, 

eliminating the need for vacuum breakers. The Uniform Plumbing Code 

states that air gaps are accepted as replacements for vacuum breakers with 

foodwaste disposing systems.

NOTE:

 To assure against leaks, tighten water harness fittings. They may 

come loose during shipment, fabrication or installation. Pressure regulators 

should be installed in areas where water pressure exceeds the recom-

mended maximum of 80 psi.

MAKE ALL PLUMBING CONNECTIONS IN ACCORDANCE

WITH NATIONAL AND LOCAL PLUMBING CODES.

DRAIN PIPING

There are two (2) drain connections to be made on the 

TroughVeyor system. The TroughVeyor reservoir tank 

drain is supplied with a simple quick-opening drain valve 

using a 2” rubber coupler to connect to your 2” drain pipe. 

3” piping is recommended for the disposer drain. These 

two (2) drain lines can be run separately or can be com-

bined per local plumbing codes.

Model 

TVL

DRAIN PIPING

OR

OR

Model 

TVR

DRAIN PIPING

INCOMING POWER

1

/

2

" CONDUIT KNOCKOUT

DISPOSER CONNECTION

1

/

2

" CONDUIT KNOCKOUT

DISPOSER CONNECTION

1

/

2

" CONDUIT KNOCKOUT

DISPOSER CONDUIT CONNECTION

NOTE:

Always use watertight 

conduit and fittings when 

wiring this product.

MAKE ALL INSTALLATIONS IN ACCORDANCE

WITH LOCAL AND NATIONAL ELECTRICAL CODES.

ELECTRICAL

The Salvajor TroughVeyor is designed for easy electrical in-

stallation. Components such as the pump motor, solenoids, 

separator motor, etc. are all factory pre-wired. The field wiring 

on the TroughVeyor consists of two (2) simple steps.

First,

 wire from the disposer to the 1/2” knockout provided 

for you on the control panel that is located on the front of the 

TroughVeyor.

Second,

 run power from the power source to the control 

panel. A 1/2” knockout is provided on the water harness side 

of the control panel.
Complete wiring diagrams will be found inside the Trough-

Veyor control panel. The disposer wiring diagram will be 

found attached to the junction box cover located on the bot-

tom of the disposer, as well as in the disposer installation 

manual.

IMPORTANT:

 The pump must be checked for proper rota-

tion. When facing the front of the pump located on the bottom 

of the TroughVeyor, the proper rotation is clockwise.

NOTE:

 The TroughVeyor is equipped with a safety lid switch 

which is located at the safety cover over the disposer. The 

safety lid switch is activated whenever the disposer safety 

cover is opened, cutting power to the TroughVeyor system.

ALL 3 PHASE/TOTAL FULL LOAD AMPS

  MODEL  208V  230V  460-480V  TOTAL HP
 300-TV
  12.64 11.66  5.83 

3.92

 500-TV  17.64 16.16  8.13 

5.92

LEFT HAND - Model 

TVL

RIGHT HAND - Model 

TVR

LEFT HAND - Model 

TVL

RIGHT HAND - Model 

TVR

4

Содержание TroughVeyor TVL Series









Отзывы: