Tel: 886. 909 602 109 Email: [email protected]
www.salukitec.com
73
c. Choose the right COM number. If the COM is right, the connection will success after few seconds.
Note that when the PC is connected to SE2031 with USB, you can go to “Device Manager” to search
“COM and LPT”. In this case, you can know which COM is used to connect currently.
If the COM is right, wait for a few seconds and the connection status will refresh to Fig.55.
The second solution:
a. Click
. Wait until it becomes
.
b. Click
again.
c. Repeat the operations 1 and 2 until the connection is successful.
After connection successes, as is shown in Fig.58, the data in red box will be empty and it will restart a new display.
It displays the value of R in default.
You can choose
to display the value of X, Y, θ, frequency and noise at top of the
red box. The software interface will display the parameters of the SE2031 current configuration. You can set other
parameters shown on the GUI.
Fig.58 Software Connection Succeeds
3. Input Configuration
The program configuration area of input signal is as shown in the red box in Fig.59. The details of the configuration are
listed on Table 3.
