HOW TO USE
1. Open the Lid by holding the kettle handle with one hand and lifting up
the Lid with the other. Fill the kettle through the lid opening with a
minimum of 0.5 litres (2 cups) of water.
2.
DO NOT
attempt to fill the Kettle while it is plugged into the wall outlet.
DO NOT
use for other than boiling water. Other liquids will contaminate
the interior of the kettle.
DO NOT
fill past the MAX level indicated in the water level window.
Overfilling may cause water to spit out when boiling.
3. Close the Lid.
4. Place Kettle on a level, dry, heat resistant surface.
5. Plug into a 120V AC wall outlet.
NOTE:
- Never plug kettle into an electrical outlet when the kettle is empty.
- Direct kettle spout away from cabinets, walls, etc. to prevent possible
steam damage.
6. Depress the On/Off Switch (‘I’/’O’) and the red indicator light will light up
to indicate that the Kettle is in the boil cycle. Once the water has boiled,
the On/Off Switch will move to the 'Off' (‘O’) position and the light will
go out.
IMPORTANT: The kettle shuts off automatically only after
the boiling cycle is complet. If the kettle is unplugged before the
boiling cycle is complete then it will begin to heat as soon as it is
plugged in again. To shut the kettle off before the boiling cycle is
complete, lift the On/Off Switch to the ‘Off’ (‘O’) position.
7. The Lid should not be opened when the Kettle is hot.
8. If you want to use the Kettle again, allow the thermal safety switch to
cool down for 15 to 20 seconds then depress the On/Off Switch to the
On (‘I’) position. If the On/Off Switch does not remain in the On
position, the water is hot enough to use without reheating.
9. Only grip the Kettle by the Handle as all other surfaces will be hot
10. Unplug cord from wall outlet before pouring water from the Kettle.
11. Return the Kettle to a heat resistant surface after use.
12.
IMPORTANT:
If the Kettle is accidently switched on when empty, the
thermostat will automatically cycle on and off to prevent the Kettle from
overheating. If this situation occurs, press the ‘O’ side of the On/Off
switch and unplug the Kettle immediately. Let the Kettle cool before
refilling.
13.
DISCONNECT
the Power Cord from the wall outlet when not in use.
4
