4
General Operation
WEIGHT HOLD
To activate weight the hold feature.
1. Press and hold the TARE/HOLD button for 3
seconds. The display shows “H_ on”.
Weigh Hold is now active, until turned off or the scale
goes to sleep.
2. Place a package on the scale, allow the scale
weight to become stable. Remove the package,
the weight of the package will remain on the
display.
To perform another weight hold transaction,
press the TARE/HOLD key to zero the scale,
repeat step 2.
If the loading weight is bigger than the weight that shows on the
display, the displayed weight will be updated by the new weight.
4. To turn off the weight hold feature, press and
hold the TARE/HOLD button for 3 seconds. The
display shows “H_oF”.
Error and Status Messages
Low Battery
If battery is discharged, the display will show
the
”bAtt“
message. The operator should
replace the batteries or use the adapter.
Over Load
If the total load exceeds the maximum capacity
of scale, the display will show the “
oooo
“
message. The weight must be removed from
the platform and not allowed to remain on the
platform.
Minus weight
If the weight value is less than –99.9 lbs, the
display will show the following: “----“.To adjust
the minus weight, press the “Tare/Hold” button.
EPROM Failure
If the
”ErrE“
message appears, the operator
should contact their scale service
representative.
