9
gine mount stand.
• Disconnect the wire connections.
• Remove the 1/4-20 fasteners that hold the throttle
control bracket to the engine mount stand. Remove
the throttle motor assembly.
CAUTION
Improper installation of the throttle motor assem-
bly can result in damage to the engine choke/throt-
tle linkage.
2.
Installation Instructions:
•Connect the electrical wiring. Be sure to connect the
brown wire to brown wire and red wire to red wire.
• Run the new throttle motor until the crank is within
opening of the throttle control bracket.
• Fasten the new throttle motor to the throttle control
bracket using the original hardware.
• Place the throttle pin assembly on the crank of the
throttle motor using hole in the middle of plastic block.
• Place the assembly onto the engine mount stand by
inserting the throttle pin into the engine choke/throttle
linkage slider.
• Keeping the throttle pin assembly parallel to the
engine choke/throttle linkage bolt the assembly to the
engine mount stand with the existing hardware.
• Run throttle motor in both directions until the slider
in choke/throttle linkage stops against choke/throttle
linkage bracket. Adjust position of throttle bracket if
necessary.
3008560
Dumpbody Tailgate Latch Kit, Universal
LB8443SST Stainless Steel D.O.T. Spreader Lightbar, 7-hole round light box (8" x 3" x 44")
LB8663SST Stainless Steel D.O.T. Spreader Lightbar, 9-hole round light box (8" x 3" x 66")
LSI
12-Volt Liquid Spray, 55 gal. poly reservoir (not for 1400475SS, 1400475SSH)
LS3
12-Volt Liquid Spray, (2) 55 gal. poly reservoirs (not for 1400475SS, 1400475SSH)
LS4
12-Volt Liquid Spray, 105 gal. poly reservoir
LS5
12-Volt Liquid Spray, (2) 105 gal. poly reservoirs
PART NO.
DESCRIPTION
Options & Accessories
1
2
3
ITEM DESCRIPTION
1
Channel, 3" x 48" Tailgate Lock
2
Channel, Short, Tailgate Lock
3
Shaft, Tailgate Lock
3008560
LB8663SST
LB8443SST
