8
your operating conditions. Check the oil level periodi-
cally and maintain the oil level. Clean and lubricate
engine’s choke throttle linkage.
1.
Check the Feed Chain tension periodically.
To check the tension, measure in 21"-25" from the
rear edge of the sills. Push up on the chain with your
hand. The conveyor chain should lift up 2"-3" off the
conveyor chain guide or cross angles.
2.
Maintain the correct tension on the following
roller chains – Gas Powered Models
• Chain A - Engine to gearbox input sprocket.
• Chain B - Spinner shaft to gearbox input
faces. Re-paint and oil all previously painted surfaces
and chains to protect from rust. Properly store the
spreader for the next season.
Feed Chain
Rear of Sill Extension
2" - 3"
21" - 25"
CAUTION
Do not over-tension the roller chain. This can cause
damage to the chain, bearings, and gearbox.
sprocket.
• The correct chain tension allows 5/16" deflection
midway between respective sprockets. Oil both roller
chains often, and at the end of each season.
To loosen or tighten Chain A: loosen the four (4) 3/8-16
X 1 carriage bolts that fasten the engine mount stand
to the engine deck and slide the engine mount stand.
• To loosen or tighten Chain B: First, loosen the spin-
ner chute fasteners and slide the spinner/chute as-
sembly. If additional adjustment is needed, loosen the
spinner shaft bearing bolts and slide the spinner shaft.
Be sure to maintain the vertical alignment of the spin-
ner shaft and bearings before tightening the hardware.
• Empty the spreader of all ice control material when
not in use to prevent a frozen feed chain & damage
due to corrosion.
• Wash out the spreader when it is not in use. At the
end of the season wash out the spreader to remove all
ice control materials. Thoroughly dry all metal sur-
3.
To minimize problems & extend the life of the
gas engine & electric clutch, the following proce-
dures are recommended:
• Maintain the spreader engine according to the
engine owner’s manual. This manual is shipped with
the spreader. The engine warranty is covered by the
engine’s manufacturer. If engine service is required,
contact an authorized service center for the engine’s
manufacturer.
• At the end of the season, remove and clean the
electric clutch.
• After cleaning, coat both mating surfaces of the
clutch with oil or light grease.
• Remove oil and grease prior to using the clutch
again.
Spreader Maintenance - Hydraulic Models
1.
Warm up hydraulic system before using.
2.
Keep the reservoir 3/4 full with high grade non-
foaming hydraulic oil.
3.
Use precautions to keep contaminants from getting
in reservoir when filling.
4.
Quick connects are a prime source of contamina-
tion.
• Clean quick connects before connecting or dis-
connecting them.
• Protect quick connects from contaminates at all
times.
5.
Lubricate all bearings with suitable type grease on
a regular basis. More frequent lubrication is recom-
mended during periods of heavy use.
6.
Maintain the proper lubrication level in all gearbox-
es with SAE 90 gear lubricant.
7.
When not in use, keep the spreader empty to
prevent freezing of material in the hopper in extremely
cold weather.
8.
To extend the life of your spreader:
• Hose down and clean after each use.
• Repaint and/or oil after each season.
Throttle Motor Assembly Instructions -Gas
Powered Models
(diagram on pg. 12)
1.
Removal Instructions:
• Carefully observe the existing installation and mark
the position of the throttle control bracket on the en-
