2
SAE GRADE 2
SAE GRADE 5
FT-LBS FT-LBS
1/4-20
6 9
5/16-18
11
18
3/8-18
19
31
3/8-24
24
46
7/16-14
30
50
1/2-13
45
75
9/16-12
66
110
5/8-11
93
150
Note: To calculate the total spreader weight
(including ice control material); add the empty
spreader weight plus the ice control material and
spreader accessories.
3.
Recommended Fastener Torques:
Maintain all fastener torques as shown in the following
table. Failure to do so may cause injury to persons.
WARNING
Verify that the above oil viscosity meets your oper-
ating temperature requirements. If not, empty and
refill with the proper viscosity oil. Before starting
spreader, check that the engine crankcase and gear-
box are filled to the proper level with lubricant.
4.
Engine Oil (gas models) and Gearbox Oil
(all models):
The engine crankcase of gasoline powered spread-
ers is filled with 1 quart of SAE 5W-30 motor oil at the
factory. The gearbox of any spreader is filled with SAE
90 gear lubricant at the factory.
WARNING
Observe the following Safety Precautions before,
during and after operating this spreader. By follow-
ing these precautions and common sense, possible
injury to persons and potential damage to this
machine may be avoided.
General Safety Precautions
• Read this entire Owner’s Manual before operat-
ing this spreader; this includes the engine Operator’s
Manuals for gas powered versions as well.
• Read all safety decals on the spreader before oper-
ating the spreader.
• Check to make sure all safety guards are securely
mounted into place before operating your spreader.
• Verify that all personnel are clear of the spreader
spray area before starting or operating this
spreader.
• Keep all loose clothing, hair, jewelry and limbs
clear of the spreader before starting or operating this
spreader.
• Do not over-load your vehicle beyond payload limits.
• Do not perform any service operation on the
spreader while it is running.
• Do not climb on or into the spreader during
operation.
• Do not ride on the spreader while the vehicle is in
motion.
• Make sure the spreader is securely fastened to the
vehicle.
• Do not operate a spreader that is in need of mainte-
nance or repair.
Safety Precautions – Gas Powered Models
• On gas powered models, make sure the engine
cover is securely fastened to the spreader before op-
erating the spreader.
• On gas powered spreader versions, never lay tools
or equipment on top of the 12V DC battery as this
could accidentally ground the positive (+) battery ter-
minal. Grounding the battery could result in electrical
shock, burns or damage to the vehicle or equipment.
• Always disconnect the battery before removing or
replacing any electrical component.
• A charging battery gives off gases that can explode
if touched by a spark or flame. Cover the top of the
battery with electrically non-conductive material to
keep sparks away from battery gases.
• If the spreader must be operated with the spreader
battery disconnected, insulate the positive (red) bat-
tery cable and red wire from the engine alternator with
electrical tape.
