19
3.
Push the double glazing in the direction of the arrow (Figure 5) and pull it completely out in order
to proceed with cleaning. At this point you can also remove the middle glazing in the oven door
(follow the procedure of Figure 6) and proceed with cleaning.
CHANGING THE LIGHT GLOBE
Before proceeding with changing the light globe, read the important
safety information.
To replace the light globe:
1. Disconnect the power supply from the power socket or switch off
the circuit breaker of the unit’s power socket.
2. Unscrew the glass lamp cover anticlockwise (note that it might be
stiff) and change the light bulb with a new one of the same type.
3. Screw the glass lamp cover back into place.
IMPORTANT:
Use only halogen lamps 25-40 W / 220 V-240 V, T300°C.
CAUTION!
Ensure that the appliance is switched off before replacing the lamp to
avoid the possibility of electric shock.
DISASSEMBLY OF CONVECTION MOTOR
Before proceeding with any servicing or repair, read the important safety information.
1.
Turn off the electrical power supply to the appliance prior to servicing it. Failure to disconnect the
power supply during service may result in an electrical shock or fire hazard.
2.
Use a screwdriver to remove the screws on the back of the cavity inside (see figure) to
disassemble the convection motor cover, and then pull it out from the clipping hole.
CAUTION!
Servicing & Repair of this appliance must only be undertaken a
suitably qualified person.
4.
When cleaning is completed, fit the parts back on by following the reverse procedure to that
described above to put the oven door back into its original condition.