27
Smarty 3X VE / Smarty 3X VE 3.0
www.salda.lt
Rated current of the plug socket must not be lower than that of the unit indicated in the technical decal.
Additional external functional nodes to be connected to terminal X16 must be connected after removing the automation plate (pull it until the plate leans
against the fixation screw) and leaving the cable reserve (~ 10cm) for automation extension.
Fig. 4.5.
When the unit control automation must be extended from the automation compartment, the limiting automation extension screw must be
unscrewed and two connectors of the automation must be disconnected.
If external units are connected to X16, they must be also disconnected prior to extending automation.
The unit must be connected to the power supply through the current leakage relay (30 mA).
Upon the full dismantling of the unit control automation and its re-installation, make sure that the connector conductors are not
damaged or otherwise broken prior to connecting automation connectors.
