10
7
8
Installing the Treadle
Find the treadle pedal (
A
) and use
B
,
C
,
D
and
E
to mount the L-bracket (
B
) as shown (
6
).
Flip the table on to its back side and use pivots
(
F
) to install the treadle in the center of the
treadle mount bar (
7
).
Ensure L-bracket (
B
) is pointing toward the back
support bar (
G
). Tighten down.
Important: Flip the table upright and check to
make sure the treadle moves freely after the
bolts are tightened. If not, loosen bolts and
reposition one of the pivots.
Before Continuing: See “Attaching a Pulley”
and “Installing the Workhorse
®
Servo Motor” in
the Workhorse Servo Motor Instructions.
Installing the Linkage Bar
Bolt the linkage bar (
H
) to the outermost hole of
the motor operation lever on the Workhorse (
I
)
and the L-bracket (
B
) (
10
).
By increasing or decreasing the overlap of the
linkage bar, different treadle pedal angles can
be achieved.
9
Oil Pan Installation
Flip the oil tray upside down and locate the two
stop screws (
J
). The stop screw that touches
the oil tray (
K
) needs to be adjusted so the
screw beneath the bracket equals 7/16
inch.
The stop screw that doesn't touch the oil tray (
L
)
needs to be adjusted to equal 5/16 inch.
Locate the two back corner cushions (
M
) and
the two front corner cushions (
N
).
Slide the four corner cushions onto each
respective corner flange and tilt the tray into the
tabletop cutout so that all four corner cushions
drop down into the ledges (
10
). The edge of the
oil tray with the crescent cutout (
O
) should be
facing the left side of the table, away from the
belt slot (
P
).
Note: The black packaging discs at the corners
of the oil pan should be removed and discarded.
5/16
"
7/16
"
B
G
I
H
B
J
K
L
M
N
J
J
K
K
O
P
C
D
E
B
F
A
6
3 |
Sailrite.com
Fabricator
®
Assembly Instructions
| 4
Standard Fabricator
®
Assembly
Standard Fabricator
®
Assembly
