After confirmation the oven is in CountDown mode and the PID will works until the countdown time is expired.
The display swaps through:
- temperature
- remaining time
the heating led shows when the heater is on and one of the < = > led is on
NOTE: to view/modify the CountDown parameters just repeat the above procedure.
Switch off
The oven can be switched off in two ways:
1) using the main switch ON/OFF. At the next switch on the oven will be again in Count-down mode and the PID will work
immediately.
2) using the
STOP
mode. Hold down
for 2 seconds, the display will show
"C.doun"
Press
until the
display will show
"StoP"
, press
to confirm. The oven is now in stand-by, the PID is inactive and all the leds are off
CLOCK MODE
Hold down
for 2 seconds to enter the parameter setting function.
Press
until the display will show
"Clock".
Press
, the display will show "CURRE" "TIME"
Press
and insert the following parameters: current year ("Y ??"), current month ("M ??"), current day ("d ??"),
current hour("h ??"), current minutes("m ??")
Set parameter value pressing
to select digit and
to modify the value
By pressing
the parameters will be memorized otherwise if you hold down
for 2 seconds you will
exit from the parameter setting function.
At the end the display will show "START" "TIME"
Press
and insert the following parameters: start month ("M ??"), start day ("d ??"), start hour("h ??"), start
minutes("m ??")
Set parameter value pressing
to select digit and
to modify the value
Press
, the parameters will be memorized otherwise if you hold down
for 2 seconds you will exit
from the parameter setting function.
Example of setpoint at 250°C one month ahead (current time: 5th october 2010 at 14:00)
"Y 10"
"M 10"
"D 05"
"H 14"
"m 00"
"M 11"
"D 05"
"H 14"
"m 00"
"t 250"
After confirmation the oven is in Clock mode. Remember that the PIDLogger doesn't accept programmed start-up ahead in the
future more than 999 hours and 59 minutes.
The display swaps through:
- start date
- start time
- setpoint temperature
the heating led above the display are off. When the start time is arrived the oven will change to SetPoint mode.
NOTE: to view/modify the Clock parameters just repeat the above procedure.
Switch off
The oven can be switched off in two ways:
1) using the main switch ON/OFF. At the next switch on the oven will be again in Clock mode and the PID will work immediately.
2) using the
STOP
mode. Hold down
for 2 seconds, the display will show
"Clock"
Press
until the
display will show
"StoP"
, press
to confirm. The oven is now in stand-by, the PID is inactive and all the leds are off
Sahara DRY,07/.2021
Page 7
