5
START – UP PROCEDURES
POSITIONING AND INSTALLATION
Follow these steps for opening the package and installing the projector in its working position:
•
Place the projector near the place it will be installed.
•
Open the package and remove the anchoring elements, accessories, and user manual.
•
Carefully read the instructions in the manual.
•
Arrange tripod or stand or any other adequate support.
•
In case of tripod or stand, position the projector on an horizontal plane and mount before the rotation pivot
in the middle of the adjustable bracket.
•
Using and adequate lifting equipment, complete the mounting on the stand or any other adequate support.
•
Tighten the M12 bolts and insert a device to prevent them from accidentally loosening.
•
Make sure all adjustable parts are locked firmly in place in the desired position.
You must verify the stability of the support elements when the projector is in working condition.
Do not install the projector where there are objects located at a distance of less than 20 centimetres from
the cooling unit.
POWER SUPPLY
The power line must be protected by a differential magneto thermal circuit breaker, while using the followspot, be
sure not to pull the cable. TRACER 1200 absorbs 1600 W at 230 V.
Connect the fixture to the mains with the enclosed power cord and plug. See the table for the colours of
the connection-cable.
When in doubt, consult a qualified electrician.
Be careful with your operations. With a high voltage you can suffer a dangerous electric shock when
touching the wires! Inside the projector, the ignitor circuit have very high voltage, over 5Kv.
The User must ensure that the power supply is provided with a highly sensitive differential circuit breaker
30m/A to protect the projector from indirect contacts, and that the grounding system PE is working
properly.
Don’t power the projector with a dimmer circuit