21
It is possible to remove at the same time, the wireless link between a group of projectors and
their transmitter:
press and hold for about 5 seconds
the PAIRING button on the transmitter
and release when the relative status led blinks. The wireless link in all the projectors will be
removed (display blinking).
To connect the transmitter to a DMX console use a cable conforming to specifications EIA RS-
485: pole twisted, shielded, 120Ohm characteristic impedance and low capacity (SAGITTER
SG DMX3 – SG DMX5).
Do not use microphone cable or other cable with different characteristics than those specified.
Terminations must be made with male / female XLR 3-pin connectors. You must enter on the
last device a terminal plug with a 120Ohm resistance (min1 / 4 W) between terminals 2 and 3.
IMPORTANT: The cables must not come into contact with each other or with the metal housing
of the connectors. The housing itself must be connected to the shield braid and to pin 1 of the
connectors.
CABLE CONNECTION
Switch OFF the wireless circuit in each projector in the submenu FUNCTION – W-Switch, select
OFF and press ENTER. Connect the DMX cables between projectors
Use a cable conforming to specifications EIA RS-485: pole twisted, shielded, 120Ohm
characteristic impedance and low capacity (SAGITTER SG DMX3 – SG DMX5).
Do not use microphone cable or other cable with different characteristics than those specified.
Terminations must be made with male / female XLR 3-pin connectors. You must enter on the
last device a terminal plug with a 120Ohm resistance (min1 / 4 W) between terminals 2 and 3.
IMPORTANT: The cables must not come into contact with each other or with the metal housing
of the connectors. The housing itself must be connected to the shield braid and to pin 1 of the
connectors.
Consolle DMX
