Putting the device into operation
SAGEM RT3000
11
Datei 8115AD002-Total.doc
Datei gespeichert
24.04.04 13:23 von EDV/ORGA
Druckzeit 24.04.04,
18:17
Status Release
!
The total number of telephones and telecomm equipment connected to the
RT3000 may not exceed a REN (=Ringer Equivalent Number) of 5. A standard
analogue telephone has the REN of 1.
!
All devices connected to one port of the SAGEM RT3000 are switched in parallel.
That means they react in the same way: For example when there are 2 telephone
sets connected to the
Telephone
port and a call comes in, both telephone sets will
ring and you can answer the call using any of them.
!
If you connect a Personal Computer, you have to install the modem driver of the
SAGEM RT3000 on the computer.
!
For security reasons, the telephone cables must remain exclusively inside the
house, not go outside the house. The maximum distance between the RT3000 and
conventional telephone sets or fax machines is 300 meters with 0,4 mm cable
assuming a total loop impedance including telephone equal to 500
Ω
maximum.
The maximum distance between the RT3000 and PC should not exceed 3 meters.
!
If the power supply adapter is disconnected, the SAGEM RT3000 is shut down.
Even if the RT3000 is powered by the internal battery (in case of a mains failure),
the power supply adapter shall be connected to the SAGEM RT3000.
3.4
Enter the PIN number
Before you can use the RT3000, enter the PIN (Personal Identification Number). You
will receive the PIN number with the SIM card from your network provider.
!
If you have received a RT3000 with Autopin function read chapter 3.5 before going
on.
To enter the PIN use a telephone set connected to the
Telephone
port or the
Fax/Modem/Phone
port of the RT3000. Use the telephone to enter the PIN (by
sending DTMF codes to the RT3000) just as you would dial a number:
When you pick up the handset (go off hook), you will hear a recurrent short beep tone,
that prompts for the PIN. Enter the PIN as shown below, then hang up (place the
handset on hook).
To enter the PIN:
*8
PPPP
It means:
PPPP
Please enter your PIN number here .
Allowed PIN numbers are 0000 to 99999.
means: listen to the confirmation tone:
a high pitched beep signals: OK
a low frequency beep-beep signals: Wrong PIN
You may have to wait 3 seconds before hearing the confirmation tone.
