Safex FlowMarker II, Инструкция по эксплуатации

Страница: 15 / 36

GAFM-II-10.12 • 34
/
14
batteries even of the same brand available on the market are partly of inferior
quality
and may be not recommended!
In addition to the possibility to charge the battery inside the device, a charging adapter
clip for the power supply is available as an extra accessory. With this accessory, you
can charge spare batteries independent of the device.
Put the clip of the charging adapter on the contacts of the spare battery, plug the power
supply into a regular (100- 240 V) outlet and charge the battery for at least 2, or better
3 hours.
The end of the charging process is indicated by a color change of the LED on
the power supply/charger.
Remainders of the fog fluid in the tank can be kept there for up to 2 years without suffer-
ing any harm. The pressurized
SAFEX
®
FOG FLUID AEROSOL CAN is also storable for at
least 2 years. It should be stored not below minus 15°C and at a maximum temperature
of 30°C.
(For very long storage of the device please pay attention to the note at the beginning of
this maintenance section!)
Due to its very fine construction details, the SAFEX
®
-FlowMarker
®
is very sensitive to
dirt in the fluid channels and in the fog fluid itself. Therefore, the fill opening and the
valve of the fluid can must be protected from fibres, fluff and any sticky liquids.
The fill stem (little tube) of the fluid can must be covered with its cap. It can be cleaned
with warm water.
After every filling, clean the fill opening of remaining fluid with absorbent paper. Before
the next filling, clean the opening of dust and fluff with a soft brush or warm water. (All
case components are made of stainless steel).
But do not let any water get into the device.
As a matter of course, the filling system of the FlowMarker has a highly efficient filter
which can be easily changed if required.
If the fog fluid from a new can fills the tank only very slowly or not at all, the cause may
be
- unless the can is empty or depressurized - a blocked filter in the fill opening.
In this case, change the filter as follows :
1. Unscrew the filter cartridge (see illustration) from the device by turning it counter-
clockwise with a coin.
2. Take the white micro filter (30 my) out of the filter cartridge, preferably with twee-
zers, and dispose of it. At the same time, remove also the black o-ring seal.
3. Gently push the new micro filter into the recess and put a new o-ring into the groove.
The o-ring must lie in the groove crease-free and evenly. Pay attention to absolute
cleanness.
4. Gently screw filter cartridge hand tight into the device with a coin.
Do not clean or re-use the removed filter, and do not clean the fill opening with
any sharp object.
Never use the FlowMarker without a filter. Even very small particles can lead to seri-
ous damage of the device.
Blockage of the fluid channels or the heat exchanger must not be removed with acid,
de-scaling agent or other detergents; this would seriously damage the device. Appro-
priate repairs can only be carried out at the manufacturer’s works or at approved service
centers. Heaters for exchange are available as spare parts.
CHARGING BATTERY
EXTERNAL
FLUID FILLING
AND TANK
CHANGING THE
FILTER