page 14
111v Tsarigradsko Shose blvd, 1784 Sofia, Bulgaria | [email protected] | www.safetyeng.eu
11. Inspection and maintenance
11.1. Daily inspection
Careful inspection is paramount to maintaining device safety; perform the inspection
procedures outlined in this section diligently and in a timely manner. Failure to follow
these procedures may lead to severe personal injury or even death!
You as an end user or operator assume complete responsibility for incidents arising
from lack of timely inspection and/or maintenance.
Self Belay device and its components shall be inspected daily before the start of each work
day in order to ensure their safety and smooth operation. The following procedures shall be
followed in order to ensure optimal safety and efficiency.
1.Overall device check
Inspect visually the Self Belay device; note any missing, deformed or broken components.
Note:
during use, it is normal for the device to receive occasional scratches and accumulate
surface damage from contact with rough surfaces. Coating will also start wearing out,
particularly in areas where the device is being held while opening or closing, as well as areas
around the key and quicklink opening This is normal and to be expected.
2. Self Belay key check
Inspect closely the Self Belay key; pay particular attention to the condition of the middle pin.
If it is bent, partly or completely broken, stop using the key and replace it immediately.
