page 11
111v Tsarigradsko Shose blvd, 1784 Sofia, Bulgaria | [email protected] | www.safetyeng.eu
Reinstall the lock washer with pliers. Make sure the washer snaps all the way in the groove.
After assembly, verify that the washer cannot be removed by hand.
9.4. Installation on quicklinks to user harness
The quicklink must be fastened securely to the harness of the user to ensure their continuous
safety when using the device. Refer to section Compatibility with autobelay devices and
harness for a list of compatible harnesses.
To attach:
1.
Loosen the quick link nut by means of a wrench and open it completely
2.
Identify the anchor point loop intended for attachment to fall arrest system. Refer to the
harness user manual for the location of this attachment point.
3.
Tighten the quicklink by using a wrench. Tightening torque: 3 Nm (2.21 lb.ft).
4.
After installation, make sure the nut cannot be turned by hand.
WARNING:
Use only harnesses compatible with the Self Belay. Usage of other types
of harnesses is not supported and does not guarantee end user safety!
