LATCH Installation
34
33
1.
Remove LATCH from
Storage Location
Or if the LATCH belt was used
forward facing,
pull it out of the
forward-facing belt path so both
hooks are on the same side of the
seat.
2.
Route LATCH Belt
Through Rear-Facing
Belt Path
Do not twist belt.
LATCH adjuster can be on either
side.
Safety Tips
Make sure harness and buckle fit your child correctly before
installing the child restraint. See pages 3-5.
Experts agree that children should remain rear facing as long
as possible. In this child restraint, your child can remain rear
facing up to 40 lb (18 kg) and up to 40 in. (101.6 cm).
3.
Reach Under Pad and
Pull Hook Across to
Opposite Side
Do not twist belt.
Belt
MUST
be in
front
of buckle
strap.
You
MUST
use the 1st or 2nd
buckle slot.
Do not
place belt
over child’s legs.
1
2
4.
Finished LATCH Routing
continued on next page
WARNINGS:
Do not use LATCH belt along with the
vehicle lap or lap/shoulder belt.
Check LATCH belt before each use. Use only if the belt can
be tightened properly and securely.
Do not fasten both LATCH hooks on same LATCH anchor
bar in the vehicle.
Secure the tether hook when used rear
facing. Attach the tether hook to stor-
age attachment as shown and gently
tighten to remove slack.
Failure to follow these warnings can
result in serious injury or death.
5.
Fully Recline the Child
Restraint
Pull out on recline handle and push
top of child restraint back.
4358-6840 Continuum.indd 39-40
4358-6840 Continuum.indd 39-40
10/16/15 2:47 PM
10/16/15 2:47 PM