43
E. Installing Rear-Facing
E-4
Install Rear-Facing with
Vehicle Belts
Store Top Anchorage Hook
(Tether)
Attach the top anchorage hook
(tether) to the base as shown.
Tighten tether to remove the
slack.
2.
Store Lower Anchor Belt
You
MUST
fasten the lower
anchor hooks to the side of shell
as shown when using the vehicle
seat belts.
1.
44
Do not use the lower anchor belt along with the vehicle
lap or lap/shoulder belt. Secure lower anchor hooks to
storage attachments when installing with vehicle belts.
Store the tether hook when used rear facing. Attach the
tether hook to storage attachment and gently tighten to
remove slack.
Check vehicle belt before each use. Use only if the belt
can be tightened properly and locked securely in place.
Failure to follow these warnings can result in serious
injury or death.
For children 22-35 lbs (10.1-
16 kg) and can sit up unassisted,
rotate the child restraint between
the 2 level to ground lines. Start by
making the bottom level to ground
line level, then rotate seat up. DO
NOT rotate past the top most upright
level to ground line.
Adjust child restraint if needed.
You may need to place a large
rolled towel(s) or foam pool
noodle(s) (A) under the front of the
child restraint to help achieve the
correct recline. Check often to be
sure padding is still in place and
the vehicle belt is tight.
A
continued on next page.
Check if Your Vehicle Belts Will
Work With This Child Restraint
This is very important because
not
all vehicle belts will work with
child restraints.
Review section D-3 and your vehicle
owner’s manual to determine what kind
of vehicle belt you have and how to lock
a child restraint in place.
Fully Recline and Place
Child Restraint in the
Back Seat Rear-Facing
For children between
5-22 lbs (2.3-10 kg),
the
bottom level to ground line MUST
be level to the ground.
3.
4.
