
35
D. General Vehicle Installation
Tighten Vehicle Belt
Push down firmly on the
child restraint and while
pulling on the shoulder belt
to tighten.
4.
Rebuckle Vehicle Belt
8.
36
Locate Locking Clip
Location
Grasp both vehicle belts
together just behind the
latch plate and unbuckle.
NOTE:
If the latch plate
ends up just at the belt path
opening, grasp the belts
on the opposite side of the
child restraint, as close to
the latch plate as possible.
5.
Attach Locking Clip
Thread both portions of the
vehicle belt onto the locking
clip, as close to the latch
plate as possible.
6.
Position Locking Clip
Position locking clip about
1 in. (2.5 cm) from vehicle
belt’s latch plate.
7.
Thread Vehicle Belt
Thread the vehicle lap/
shoulder belt combination
through the rear-facing
belt slot.
2.
1
2
Pull Vehicle Belt Across
Child Restraint
Thread vehicle seat belt
under
pad in front of
buckle strap to the opposite
side. Buckle vehicle belt.
Do not place vehicle belt
over child’s legs.
3.
NOTE:
The buckle
MUST
be in the 1st or 2nd buckle strap
slots when rear-facing. Any slot can be used for
forward-facing.
You may need to place a
large rolled towel(s) or foam
pool noodle(s)
(A)
under the
front of the child restraint
to help achieve the correct
recline. Check often to be
sure padding is still in place
and the vehicle belt is tight.
Rear-Facing
For Chi
ldren 5-22 lbs
(2.3-10 k
g)
Bottom Li
ne MUST Be
Level with the
Ground.
Rear-Facing
For Children 22-40 lbs (10.1-18 kg)
AND can sit up unassisted
Most Reclined Lev
el to Gr
ound Line
Most Upright Level to Ground Line
Recline range is between
the 2 level to ground lines.
Review instruction manual.
4360-xxxx
N
SCHILD
T
NSONTHISCHILD
EWRITTENIN
STRU
CTIONS
EBACKO
FTHEBASE
lt-P
ositioning B
ooste
r
40-100 lbs
(18.1-45.4 k
g)
43-52 inches
(110.1-132.1 cm)
A
4358-6549 Elite 65 S1.indd 37-38
4358-6549 Elite 65 S1.indd 37-38
1/24/14 3:40 PM
1/24/14 3:40 PM