
C. Basic Use
25
Harness MUST be threaded over the metal bar.
Harness system must be reattached correctly.
Buckle’s metal retainer must be completely
through pad and shell.
Failure to follow these warnings can result in
serious injury or death.
Thread Harness OVER
Metal Bar
7.
Attach Harness Straps
to Splitter Plate
Fit loops on harness ends
completely on
the splitter
plate.
8.
4
5
6
Thread harness straps
through each buckle
tongue
(4)
. Thread the
chest clip
(5)
. Do the same
to the other harness end.
Do Not twist harness.
Push harness ends through
slots in headrest
(6)
.
6.
Thread Harness Guides
on Harness Strap
Slide one harness guide on
each harness strap end.
4.
Secure Harness Guides
Press harness guides into the
holes in the pad and shell.
5.
3.
Thread Harness Strap
NOTE:
For easier assembly,
remove the harness guides.
See section C-7, step 4.
Thread the harness down
through slot on left side
of plastic shell
(1)
and up
through slot on right side
(2)
.
NOTE:
Make sure sewn end
of the harness strap loop
faces the buckle before
starting.
Take both ends of the
harness and make them
even in length.
NOTE:
Make sure harness
tightening strap is between
the harness strap and shell
as shown.
1
2
26
4358-6549 Elite 65 S1.indd 27-28
4358-6549 Elite 65 S1.indd 27-28
1/24/14 3:40 PM
1/24/14 3:40 PM