
22
C-6
Reclining Child Restraint
This child restraint has 3
recline positions:
Rear-Facing -
Recline
restraint so that the level
lines on shoulder belt-
positioning guide are level
with ground.
Forward-Facing -
2
Semi-
reclined or
3
upright.
NOTE:
When forward-
facing, the recline position is
to be used only to install the
child restraint flush against
the back of vehicle seat back.
To Recline
Pull out on handle.
For upright position, pull out
on handle and position the
child restraint upright.
Lumbar Support
(on select models)
To remove the lumbar
support, loosen harness
system and pull the lumbar
support out from behind the
harness system.
21
C. Basic Use
1
2
3
Harness system
MUST
be removed to use this
child restraint as a Belt-Positioning Booster.
Remove Harness
Straps from Splitter
Plate
Fully loosen harness
straps. Locate splitter
plate on the back of the
seat and unfasten the
harness straps.
1.
Store Splitter Plate
Raise headrest all the way
up. Store splitter plate
by pushing it through one
opening and out the other.
2.
Remove Harness
Straps
Pull harness through the
slots from the front
(1)
.
Unthread harness from the
chest clip
(2)
.
Unthread harness from the
buckle tongues
(3)
.
Pull harness out of shell
(4)
.
3.
C-7
Removing Harness System
1
2
3
4
continued on next page.
4358-6549 Elite 65 S1.indd 23-24
4358-6549 Elite 65 S1.indd 23-24
1/24/14 3:40 PM
1/24/14 3:40 PM