14
MAINTENANCE
Lift level tool:
SAFE 91245
1. Connect the cables for the gun to the pinbrazing
unit and turn on the unit and select P1. Set the dial
on the back of the gun to “0”.
2. Insert the brass part of the tool in the pin holder
and fit the plastic part in to the ring holder.
3. Press the trigger on the gun and watch the
brass rod.
Important!
Press the tool completely against the gun when
triggering the gun.
Otherwise the gun may be damaged!
Important!
Hold the gun so the tool is horizontal.
4. The lift level is calibrated when the brass rod
is in same level as the outer plastic sleeve.
Tolerance ±0,2 mm.
If the brass rod stick out more than 0,2 mm, then
the gun needs to be calibrated, see point 6 on the
next page.
If the brass rod goes in more than 0,2 mm, then
the gun needs to be calibrated, see point 7 on the
next page.
If the gun is not calibrated see seperate instruction
for adjusting of the gun.
The normal liftheight is 2mm. This is very important for the arc and energy amount.
Too high liftheight increase the risk of a “coldbrazing”, too low liftheight reduce the
time and increase misfires.
IMPORTANT
Advanced maintenance work
,
Adjusting the liftlevel.
