9
7.0 Automatic test
In the initial interface, press four times 6 (6666) followed by the
TimeSet key. A prompt is displayed, as shown in the following figure.
Press the OK key to enter the automatic test mode. The test sequence
is FLASH test, TFT test, FP Reader, Key test, and RTC test in turn.
Ensure the stability of the power supply during the tests, especially
during the FLASH test. Otherwise damage may be caused to
the system hardware.
8.0 Attendance Management
The device is equipped with USB interface power and backup battery. When the USB interface power adapter is
supplying power to the device, the backup battery is charged at the same time for not less than eight hours. Once
the power supply is cut off or the USB interface power is unavailable, the device automatically switches to the
backup batteries to obtain power. The fully charged backup batteries enable the device to run for approximately 4
hours.
9.0 Gerenal remarks
To authenticate with a password, first enter the User ID. Users can operate the TA with their RFID card/Key fob or
fingerprint without entering their User ID.
To change between the different Check-In/Check-Out modes, press <In/Up> or <Out/Down>.
When the TA is unable to work normally due to error operations, restart the device by pressing the reset button at the
left hand side of the terminal by means of a pointed tool.
For all PC communication matters via USB, see the Time Attendance software manual.
Back-up regularly! You can do this by means of the Backup button in the software (in “Settings”).
Safescan is not responsible for any loss of data due to problems with the device and/or software.
Tips for a succesful use of the fingerprint sensor positioning of the finger
English
| nEdErlAndS | dEuTSch | FrAnçAiS | ESpAñol | iTAliAno | porTuguêS
ESC
OK
FLASH Test
Continue?
Pls Keep Pwr On
