Safe Fleet PRIME DESIGN VRR-GM31G-ST, Быстрый старт

Страница: 7 / 12

Prime Design Limited Warranty. Seller’s sole and exclusive warranty (and Buyer’s sole and exclusive remedy and Seller’s entire liability for any breach thereof) with respect to the Goods is set forth in the Limited Warranty document available at primedesign.net/warranty-liability
(the “Prime Design Limited Warranty”).
▪
TM & © 2020 PRIME DESIGN. PROTECTED BY ONE OR MORE OF THE FOLLOWING PATENT NO.’s 6427889, 6764268, 6971563, 8991889, 9415726, 9506292, 9481313, 9776476, 9796340, 10470565, 10486608 AND OTHER PATENTS PENDING
7
View From Vehicle Front
Fig. C
L Post Bolt
Fig. D
Fig. E
Flat Washer
Lock Washer
M8 x 20MM Hex Bolt
Do not tighten
1.3
Place the Slide L Post Bracket Clamp into the inner bottom
groove of the Slide Assembly, then position it into the L Post
Bracket. Assemble the Slide L Post hardware, but do not
tighten until Step 1.4
Note: The orientation of
the bolt hole faces away
from the Slide Upper.
Lightly tighten the Slide L Post bolt, then finalize the alignment
of the front edge of the Slide L Post as shown below in Figure C.
This must align to the label’s L Post positioning arrow shown in
the closeup in Step 1.1. Torque the L Post bolt to 90 in-lbs.
1.4
SLIDE Z POST
2.1
Place the Slide Z Post Clamp onto the top of the Slide
Assembly, ensuring the Z Post Clamp seats into the Slide
Upper lip as seen in Figure D below.
2.2
Place the Z Post into the Mounting Clamp Assembly ensuring
the Slide Z Post seats into the Clamp’s top groove as seen in
Figure E below. Do not tighten until of Step 2.4
VRR-GM31G-ST BO
X
ASSEMBL
Y INSTR
UCTIONS–L POSTS & Z POSTS