Place the second J Shelf over the top of the U-
Brace rectangle and between the End Panels, and
push down into position. Use the rubber mallet (or
hammer with a block of wood) at each corner as
before, to be sure the barbs engage the pockets.
IMPORTANT: after the corners are in place, hold the
center top of the Shelf down while tapping UP on the
U-Brace joint underneath, until the U-Braces snap into
the shelf (see inset).
7
Slide a L Locking Plug into the center channel of
one of the End Panels, with the slanted barb facing
the End Panel and the notched corner up and facing
the center of the cart. Push the Locking Plug down
between the End Panel and the Shelf, until the barb
snaps into place. Repeat at the other End Panel.
9
Slide the remaining two K Side Rails down into
the top slots of the End Panels.
8
Q
Q
Q
Q
Q
Align the M Endcap over the H End Panel
Without Holes
. Press firmly down until it
snaps into place (it may help to snap one end
first, then the other; or carefully use a rubber
mallet, or a hammer with a block of wood, to
tap it into place).
10
5330-37: 3 of 4; Rev. 1: 10/01
Safco Products Company, New Hope, MN 55428
Q
Q
Q
Q
Q
SLOT
Q
Q
Q
Q
Q
K
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
L
BARB
NOTCH
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
J
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
H (Without Holes!)
Q
Q
Q
Q
Q
M
