Assemble the two I U-Braces to form a rectangle,
snapping the two sections together at the overlapping
ends. IMPORTANT: find the word “TOP” molded into
the upper corners; this will identify the top of the
rectangle for the next step.
3
Place one of the J Shelves between the End
Panels, near the bottom of the U-Brace rectangle.
Press the Shelf down firmly, keeping it aligned over
the Base Plate. The last inch or so will require
tapping sharply with a rubber mallet (or a hammer
with a block of wood to protect the surface) at the
centerline of the Shelf to snap it over the U-Braces,
then at each of the four corners until the barb on the
Shelf corner enters the pocket in the End Panel (see
inset). HINT: Unsnap the top of the U-Braces so the
End Panels can spread slightly while doing this step,
then resnap the U-Braces.
5
Slide the assembled U-Brace rectangle (with the
top up) down into the channels in the End Panels.
There are keyhole slots and studs, similar to those
on the Base Plate and End Panels; as the rectangle
approaches the bottom of the channel, push the
End Panels together and continue sliding the
rectangle down all the way into the channel in the
Bottom Plate.
If the side studs have properly
engaged the keyhole slots, the inside face of the
U-Brace rectangle will be flush with the End
Panel.
4
Tuck one end of one of the K Side Rails into the
bottom slot on one of the End Panels, along side
the Shelf, with the lip of the Side Rail up and
facing the Shelf. Tip the Side Rail up at an angle
as shown, and align its upper end with the slot on
the other End Panel. Tilt the Side Rail down into
position, so both ends are within their slots.
Repeat with another Side Rail on the other side of
the Shelf.
6
5330-37: 2 of 4; Rev. 1: 10/01
Safco Products Company, New Hope, MN 55428
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
BARB
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
K
LIP FACING
UP AND IN
SLOT
Q
Q
Q
Q
Q
I
Q
Q
Q
Q
Q
J
